New polymer clay earrings

With both sets of my polymer clay earring components created in Julie Picarello’s workshop – the round discs and the long “lizard tails” – I drilled a small center hole approximately 1/8″ from the top of each piece. That is where the similarity in the embellishment process ends.

Using gold-filled wire threaded through the drilled hole, I made a wrapped “hanger” for each of the round discs and then attached a handmade gold-filled ear wire. I then created some crystal bead dangles using the same gold-filled wire and attached them to each ear wire with a small jumpring.

Using Silamide thread (my favorite for beading) and size 15 seed beads, I used the drilled hole to secure a ring of beads around the top of each “tail”. From that base ring, I worked peyote stitch first up around the top of the piece and then on the bottom of the ring, decreasing when needed to form fit the beads around the “tail”. I added a small pearl for embellishment and then a loop at the top so that the pieces could hang comfortably from ear wires.

Next up…..the pendants…

Advertisements